2024 Ohio Reef Frag Swap

2024 flyer
« previous next »
Pages: [1]   Go Down

Author Topic: Autodesk Inventor  (Read 2228 times)

0 Members and 1 Guest are viewing this topic.

Offline UDJustin

  • Adult
  • ****
  • Posts: 935
Autodesk Inventor
« on: January 28, 2009, 23:50:13 »
So I have been wanting to get a calcium reactor and I have seen plenty of DIY designs out on the web... being that I work at Aquariums Etc. Joel has a reactor there that I happened to look at and grab a few quick measurements off of. So I have been trying to throw a design together and this is my start I guess its not done by any means but I thought I would post a pic up that i took with my cell phone. I dont think the site would support inventor files so this is why I posted the pic from my cell phone.

Logged
If you didn't know I'm kind of a big deal...

Offline cyberwollf

  • 2010 FragSwap Chairman
  • Posts: 3,268
Re: Autodesk Inventor
« Reply #1 on: January 29, 2009, 08:01:28 »
You can also do a print screen (Fn + insert. on my laptop) paste it in MSPaint or something and save JPG
Logged
75G Mixed Reef w/ 30G sump/refuge

Electrical Engineers do it on impulse, with faster rise times, with more power, and less resistance at higher frequencies, without shorts, until it Hertz

Pages: [1]   Go Up
« previous next »
 

Powered by EzPortal