gyre 250 pump not running

[Reef Tank 2.0]

Does anyone know if the gyre 250's controller is smart enough to turn the gyre pump off if there is a problem with the pump?

For some reason, the display on the controller keeps showing pump A OFF.  I have checked it this morning, and now, same reading.  Pump B is the only one running.
The pumps usually run in OGC mode.  I changed it to the other auto mode and the display would show the pump running for about 2 seconds.  then the display would switch back to "off".   I can't keep it running or come on for that matter.  Pump B runs as it should.

Has anyone else had this same problem?

[Reef Tank 2.0]

i removed the pump for cleaning, and also updated the firmware for the controller.  Hopefully this will solve my issue.

[Reef Tank 2.0]

after explaining my issue to coralvue, Carlos narrowed it down to that the pump motor block was shot.
They are sending me a replacement.  Hopefully that is the solution.

Apparently the controller is smart enough to know when there is a problem with the pump, and that it's not working.  After a couple attempts, it will turn itself off.  As mine did.

I will reply back once solved.

Coralvue answered and replied to my ticket in less than a couple hours.

[Topekoms]

Just had the same thing happen to mine new motor works like a champ.