Ohio Reef
Reef Discussion => Equipment => Topic started by: Reef Tank 2.0 on January 09, 2018, 18:54:53
-
Does anyone know if the gyre 250's controller is smart enough to turn the gyre pump off if there is a problem with the pump?
For some reason, the display on the controller keeps showing pump A OFF. I have checked it this morning, and now, same reading. Pump B is the only one running.
The pumps usually run in OGC mode. I changed it to the other auto mode and the display would show the pump running for about 2 seconds. then the display would switch back to "off". I can't keep it running or come on for that matter. Pump B runs as it should.
Has anyone else had this same problem?
-
i removed the pump for cleaning, and also updated the firmware for the controller. Hopefully this will solve my issue.
-
after explaining my issue to coralvue, Carlos narrowed it down to that the pump motor block was shot.
They are sending me a replacement. Hopefully that is the solution.
Apparently the controller is smart enough to know when there is a problem with the pump, and that it's not working. After a couple attempts, it will turn itself off. As mine did.
I will reply back once solved.
Coralvue answered and replied to my ticket in less than a couple hours.
-
Just had the same thing happen to mine new motor works like a champ.