This evening I got a message on my Apex Fusion board about a Temperature fault in my system. I opened up my Fusion and saw what I captured in the picture below? Is this the Apex language that one of my Temp probes has said goodbye? Using the Apex is weird sometimes, we build parts / write syntax script and get it too run but when it breaks down I get like mental relapses.
At this time I am having a "memory stuck fault of my own" , question: I run a Finnex heater with no controller, my script for the heater to run is simple but I do not tie it to anything for actual control. The pic attached says 20.5 on one probe and 83.6 on the other probe and the heater was still on - how would my heater know to shut off if it is not tied to anything? I bought another Finnex heater later and it has a controller. Both heaters are on my EB8 outlet. thanks for reading.