2024 Ohio Reef Frag Swap

2024 flyer
« previous next »
Pages: [1]   Go Down

Author Topic: Different Bulkhead Question  (Read 1076 times)

0 Members and 1 Guest are viewing this topic.

Offline xXTheWendigoXx

  • Adult
  • ****
  • Posts: 446
Different Bulkhead Question
« on: July 16, 2008, 11:56:09 »
Anyone know where I can get a hold of a 3/4 bulkhead? Preferably threaded on the inside but at this rate I can be flexible.
Logged

slandis3

  • Guest
Re: Different Bulkhead Question
« Reply #1 on: July 16, 2008, 13:33:35 »
i bet aquarium ect and north dixie reef has them in stock.Im not sure but i think just coral stocks them as well. 
Logged

Offline Joel

  • Adult
  • ****
  • Posts: 1,384
Re: Different Bulkhead Question
« Reply #2 on: July 16, 2008, 17:48:13 »
I got 3/4" thread by thread only, no slip type.

Joel
Logged

Offline CoralBeauties

  • Lifetime Premium Member
  • Adult
  • *****
  • Posts: 1,804
Re: Different Bulkhead Question
« Reply #3 on: July 16, 2008, 22:24:20 »
You can also get them on ebay if you need the slip fittings that joel doesnt have.

Anyone know what size hole in millimeters I would need to drill for a 1/2 inch bulkhead?
Thanks
Jeff
Logged

NORTHDIXIEREEF

  • Guest
Re: Different Bulkhead Question
« Reply #4 on: July 16, 2008, 22:40:57 »
DO NOT KNOW IN MILIMETERS BUT A 1/2" BULKHEAD HAS A HOLE REQURIMENT OF 1 1/8". HOPE THIS HELPS JEFF

I HAVE 3/4" SLIP/SLIP AND SLIP/THREADED BULKHEADS IN STOCK.
Logged

Offline ohioreef

  • Lifetime Premium Member
  • *****
  • Posts: 4,673
  • Founding Member
Re: Different Bulkhead Question
« Reply #5 on: July 17, 2008, 12:25:33 »
There are 2.54cm/in so a 1 1/8 hole would be 2.8575cm which is 28.575mm.
Logged
Pages: [1]   Go Up
« previous next »
 

Powered by EzPortal