Welcome to Ohio Reef!

As a guest you can only see a small portion of our online content. Please register it is free and only takes a minute. Click here to Register now. 


Author Topic: Calcium 2 Part Question  (Read 345 times)

0 Members and 1 Guest are viewing this topic.

Offline SweetReefOH

  • Premium Member
  • Elder
  • *****
  • Posts: 1,452
Calcium 2 Part Question
« on: May 14, 2019, 14:52:56 »
Since rebooting the 75, I have not had to dose Calcium until now. Iíve had my BRS 2 part Calcium still attached to my DOS for the last 5 months. Iím needing to start dosing again but I donít know if the Calcium solution thatís been sitting in the container and tubing would be ok to dose. What are your thoughts? Is it OK to use?

Offline dbjonesjr

  • Premium Member
  • Juvenile
  • *****
  • Posts: 238
Re: Calcium 2 Part Question
« Reply #1 on: May 14, 2019, 16:02:07 »
If you donít see deposits Iíd think youíll be fine dosing the old solution.

Offline Gary

  • Premium Member
  • Adult
  • *****
  • Posts: 702
Re: Calcium 2 Part Question
« Reply #2 on: May 14, 2019, 21:38:45 »
It is safe to use. The calcium chloride will stay in solution unless there has been a significant amount of evaporation. If there is some precipitation then add some RO water.

Offline SweetReefOH

  • Premium Member
  • Elder
  • *****
  • Posts: 1,452
Re: Calcium 2 Part Question
« Reply #3 on: May 15, 2019, 07:21:11 »
Thanks guys. I think there was minimal, if any, evaporation and the mix looks clear. So Iíll go ahead and use it. Thanks again!

 

Powered by EzPortal